Scantronic 8136 Betriebsanweisung PDF herunterladen (Seite 22)

22 of 44 496339 Issue 1

IDIS Programming Errors

You may see one of the following messages on the second line of the display

while programming IDIS modules/sensors. If so follow the procedure indi-

cated.

OUT OF RANGE The module is blank or incorrectly programmed.

Carry on and try to program the module. If you do

not succeed then use a new device and return the

original to the manufacturer.

NOT IDIS ZONE You have tried to program a zone number less than

9. Zones 1 to 8 are FSL zones.

NO DEVICE FOUND There is nothing connected to the programming

pins on the IDIS Expander card.

DEVICE FAULTY The system failed to program the device. Try again

to program the module. If you do not succeed then

use a new device and return the original to the

manufacturer.

FREQUENCY ERROR The device or module is not programmed correctly.

Try again to program the module. If you do not

succeed then use a new device and return the

original to the manufacturer.

NON SCANTRONIC The module is not a Scantronic IDIS device. The

module cannot be used.

Programming Zones

Figure 11. The Zone Display for Menu 32

Zone Types. You assign each detector a zone type so that the control panel

can give the appropriate response. Types include, for example, normal

alarms, 24hour alarms, fire alarms and several others.

Zone Attributes. You can further modify the way the control panel responds

to each zone by assigning a zone attribute. For example, the “chime” attribute

allows you to program the panel to sound a chime tone every time a particu-

lar detector is triggered.

IDIS Programming Errors 8136

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Keine Kommentare

Scantronic 8136 Betriebsanweisung Seite 22