Scantronic 9800+ Betriebsanweisung PDF herunterladen (Seite 4)

4 496247 Issue 4

Figure 1. 9800+ Keypad

The keypad has the following displays and controls:

A, B, C LEDs These LEDs (Light Emitting Diodes) glow to show

which Level is set. The LEDs are dark when the

Levels are unset. Note that the installer can pro-

gram the system to hide the display.

Day LED The Day LED glows when the system is unset. The

LED goes dark when the system is set. Note that

the installer can program the system to hide the

display.

Fault LED The Fault LED glows when the system is in alarm,

if the system has detected a fault on the telephone

line, or if the internal battery has failed.

Service LED The Service LED glows when the panel needs an

engineer to reset it, or the system has detected an

internal problem. Call your alarm installer.

Power LED The Power LED glows when the system is using

mains power. If the Power LED flashes slowly then

the mains power has been disconnected and the

system is running off the stand-by battery.

LED Display The system displays information and instructions

through the two character LED display.

1. Introduction

2 digit Light Emitting

Diode (LED) Display

Optional programmable

panic alarm keys. Press

keys 1 and 3 together

Omit and Clear keys

Levels LEDs (Set or

Unset)

Level setting keys

Power

1 2 3 4 5 6 7 8 9 ... 19 20

Keine Kommentare

Scantronic 9800+ Betriebsanweisung Seite 4