Scantronic 4603 Installationshandbuch PDF herunterladen (Seite 21)

496372 Issue 1 21 of 34

Tilt Switch - The buzzer starts a warning tone approximately 12 seconds

after the unit tilts more than 45 degrees from vertical. The warning tone lasts

for 12 seconds while the unit is tilted. At the end of the warning tone the unit

sends an alarm signal to the receiver if it is still tilted. Restore the unit upright

to silence the warning tone.

Manual Over-Ride - Press the grey button on top of the unit to temporarily

disable the tilt switch. After you press the button the unit ignores the tilt switch

for 7 minutes. At the end of that time the unit will sound the buzzer as it

comes back into use. Press the grey button again for another delay. This

facility lets you work without causing false alarms.

Technical Specification

Dimensions h x w x d 102 x 44 x 20mm.

Input supply 3.7V Lithium battery.

Temperature -10°C to +55°C. Humidity up to 80% (non

condensing).

Frequency 173.225 MHz.

Power output 1mW.

Fully DTI approved to MPT1344 for alarm use only. No licence required.

BS6799:1986 Classes 1-3.

Coding The Transmitter

Remove the self-tapping screws and carefully ease the top of the case

upwards. Set the site code on the large 10-way DIL switch. Note that UP is

ON and DOWN is OFF. Do not set all switches to ON or the transmitter will

not work correctly.

NOTE: The 4606-55 is not compatible with the 4611/4613 single channel receivers.

4600

Use the same switch settings given for 4604. Tilt is Tamper, the two side

buttons are Alarm.

4612

Set switches as described for the 4605.

4618/9

Set switches as described for the 4605.

4660/75

Refer to the appropriate installation manual.

4606

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Keine Kommentare

Scantronic 4603 Installationshandbuch Seite 21