Scantronic 4603 Installationshandbuch PDF herunterladen (Seite 33)

496372 Issue 1 33 of 34

4624

c) To allow a second 4624 to output to channels 5 - 8 on the receiver, set

switch number 8 on the transmitter to ‘Off’.

Note: Switch number 8 on the 4618/9 Receiver Identification switch can be in any

position.

For more information refer to 4618 Installation Guide.

Identification Code Selection 4612

Set switches 1-8 on the 4624, to the site code of the 4612. Set switches 9-10

on the 4612 to off and set the mode switch for 2-Channel. Leave channels C

and D on the 4624 open, e.g., unlinked.

Operation

Channel A on the 4624, operates channel A on the 4612.

Channel B on the 4624, operates channel B on the 4612.

Note : For more information, refer to ‘4612 Installation Guide’.

Identification Code Selection 4660/75

Refer to the appropriate Installation Manual.

Note : The 4624 is not compatible with the 4600 or 4611/4613 receivers.

Low Battery (Power) Reporting

The transmitter constantly monitors the input power voltage. If it drops to 9.5

volts +/-1 volt for more than 2 minutes, the transmitter will automatically

transmit the state of all inputs and ‘low battery’. This will be transmitted every

2 minutes thereafter until the voltage has been restored to a nominal 12 volts.

1 2 ... 28 29 30 31 32 33 34

Keine Kommentare

Scantronic 4603 Installationshandbuch Seite 33