Scantronic 808 Betriebsanweisung PDF herunterladen (Seite 14)

14 496235 Issue 1

4. Special Functions

3. Press C or D to change between D (disabled) and E (enabled).

The display shows: CHIME E

4. Press Enter to save the change.

Testing the System (Menu 4)

You can set the system so that it will allow you to walk round the premises

and test each of the detectors (a walk test). At the same time you can also

test the external bell and strobe. Choose a time when the premises are

empty to carry out the test, otherwise people may trigger any movement

detectors before you do, and confuse the results of the test.

If any detector fails the test then call your alarm company and ask them to

check the system.

Note: If your system is fitted with 24 hour or personal attack detectors, you cannot

walk test them. If you wish to test them call your alarm company.

Walk Test

1. Key in your access code.

2. Press Menu followed by 4.

The display shows: 4-TEST OPTNS

3. Press Enter.

The display shows: WALK TEST

4. Press Enter.

The top line of the display shows the total

number of detectors to test, while the

bottom line shows the zone number of each

detector to be tested, for example: 07 TO TEST

01 02 >

5. Walk round your premises and trigger each detector. Note: do not

trigger any 24 hour or personal attack detectors (they will not appear in

the list of detectors to be tested). If you do trigger a 24 hour or personal

attack detector the system will raise an alarm.

As you trigger a detector the internal sounder gives a tone, and the

zone number disappears from the display.

When all detectors shown on the list have been

tested successfully the display shows: WLK TEST

COMPLETE

Note: You can abandon the test at any time by pressing Menu.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Keine Kommentare

Scantronic 808 Betriebsanweisung Seite 14