Scantronic 808 Betriebsanweisung PDF herunterladen (Seite 6)

6 496235 Issue 1

2. Everyday Operation

The 808 provides several different ways for setting the system. All methods

(except using a Keyswitch) require entering your access code at the key-

pad. The Keyswitch method uses a key in a special switch fitted outside your

premises. "Setting the System" below describes each method. Ask your

Installer to provide the method that suits your site best.

During installation the Installer programs the system to create an exit route

for your premises. When setting the system you must follow this route to

leave the premises. Similarly you must follow a specified entry route when

going into the premises in order to unset the system. If you stray from these

routes you may cause a false alarm.

Note: The system may be programmed so that your access code can set some

Levels but not others. See "5. Supervisor".

Setting the System

Timed Setting

With Timed Setting the system sets after a programmed exit time. Ask your

Installer to make sure the exit time is long enough for you to leave the

premises and close the final door. The exit time starts when you finish enter-

ing the set command at the keypad. During the exit time the keypads give a

continuous exit tone to warn you that the timer is running. If you hear an

interrupted tone from the keypad when you try to set the system then one of

the doors on the exit route is open. Make sure that they are all closed.

1. Close all doors and windows.

2. Key in your access code at the keypad.

3. Press the appropriate Level button.

The keypad starts the continuous exit tone, the

Level LED flashes, and the display shows: READY LEAVE

4. Leave via the designated exit route. Close the final door.

At the end of the exit time the system sets, and stops the exit tone. The

Level LED glows to show which Level is set.

You can also set the system by entering your access code and pressing

Enter. The system will set to the highest Level that the Installer has pro-

grammed.

If you do not close the final door before the end of the exit time then the

system gives an internal alarm and does not set. Go back to the keypad and

unset the system, see "3. After an Alarm".

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Keine Kommentare

Scantronic 808 Betriebsanweisung Seite 6