Scantronic 808 Betriebsanweisung PDF herunterladen (Seite 21)

496235 Issue 1 21

3. Press A or B until the display shows the user number you wish to use

for the duress code.

The display shows (for example): U7-CNOCO

4. Press Enter.

The display shows: U7C_

5. Key in the duress code and press Enter.

The display shows: CONF_

6. Key in the duress code again.

When you key the last digit of the duress code

the display shows: U7-DURSN

7. Press C or D to change from "N" (disabled) to "E" (enabled).

The display shows: U7-DURSE

8. Press Enter.

The system saves the change and the display shows: U7-ARMON

9. Press Menu to finish programming.

If you want to remove a duress code from a user number, follow steps 1 to 8

again but at step 7 press C or D to change the display to "DURSD".

Giving a User Arm Only Access

1. Start menu 8.

2. Press Enter until the top line of the display shows "U1-ARMON".

3. Press A or B until the display shows the correct user number.

The display shows (for example): U2-ARMON

4. Press Enter.

The cursor moves to end of the display: U2-ARMON

5. Press C or D to change between "N" (full use) and "Y" (arm only).

6. Press Enter.

The system saves the change and the display shows: U2-OMITN

Allowing a User to Omit Zones

1. Start menu 8.

2. Press Enter until the top line of the display shows "U1-OMITN".

3. Press A or B until the display shows the correct user number.

The display shows (for example): U2-OMITN

5. Supervisor

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Scantronic 808 Betriebsanweisung Seite 21